Engineering is a constantly evolving field, and Electrical and Electronics Engineering are at the forefront of innovation. In today's world, where sustainable energy sources, IoT applications, and advanced electronics play a crucial role, engineers are ta ...
A distributed power generating system can run in an off-grid or off grid mode and can be powered by either sustainable or nonrenewable energy sources. The widespread use of renewable energy sources, like grid-connected solar systems, presents distribution ...
This paper describes a power factor improvement of canonical switching converter for BLDC motor by using voltage follower technique. In this paper (BLCSC) Bridge Less Canonical Switching Cell Converter runs in a discontinuous inductor current mode. Due to ...
This papers deals with the cost-worthy design of an embedded device for real time monitoring of newborn babies in the incubator. In smart incubator a child's medical data can be checked through mobile phones or computers by the doctors or nurses from the ...
One of the solid state switch mode rectification converters is SEPIC converter. This paper presents the design, simulation and development of single phase AC-DC SEPIC converter with 1.5W output power. The non-isolated SEPIC converter is performed in this ...
In current scenarios, many water pumping systems are available using solar PV, windmill, and diesel power. This paper suggest hybrid source (i.e.) combination of solar & wind energy, since solar & wind provides better performance and reliability. ...
An integration of distributed generations (DGs) to the utility grid has raised the need for good power quality, safety operation and islanding protection of the grid interconnection. This paper presents the classification and detection of faults in a dist ...
In traditional inverters, if any one of the switches is failed due to short circuit or open circuit, it is too difficult to get the continuous power and the amplitude of the output waveform also changed. It causes the power quality issues and production a ...
Nowadays, the DC distribution system has been suggested, as a replacement for the AC power distribution system with electric propulsion. This idea signifies a fresh approach of issuing energy for low-voltage installations. It can be used for any electrica ...
Voltage constrained DSTATCOM-based voltage controller is executed for low voltage appropriation system. To meet grid code, unexpected investment postponing, voltage regulator is designed while a complete arrangement could be wanted to tackle guideline iss ...
